Latex Gloves Manufacturing Process

- Jun 28, 2019-

The rubber is first sliced by a rubber mixing machine, and then sliced and sent to a sol cylinder and a gasoline mixed sol. After the sol is emulsified and prepared, the latex intermediate tank is pumped. The rubber solution dissolved in gasoline is fed from the top of the distillation column, heated by steam distillation, and the light component gasoline is heated to a gas phase, and the gasoline gas is mixed and cooled by cold water in the oil and gas cooler. The oil-water mixture is then separated from the oil and water, and the oil moisture layer. The upper layer of gasoline is recovered, and the lower part of the water is pumped to the cooling tower for cooling. After cooling, the gas gasoline of the distillation tower is cooled. The distillation tower is sent to the latex mixing tank according to the pressure of the mixture, and the mixture is prepared, and then the centrifuge is separated from the glove material latex. After being toned and filtered, it is ready for use.

The latex glove model is first cleaned by acid and alkali, and washed with water. The washed model is first immersed in hot water and heated to the immersion coagulant and immersed for dipping. After dipping, send the oven to start drying, add fiber inner sleeve, rinse hot water and then send it to the oven for vulcanization and drying. After the mold is released from the mold, the air is inspected, the low temperature is set, the medium temperature is dry, washed, dehydrated, dried and then packaged to send the finished product warehouse.